Fortin EVO-FORT2 Bypass Module T-harness for Ford EVO-ALL & THAR-FORD2(EVOFORT2)

Description

The EVO-FORT2 is the ultimate Factory Fit, ALL-IN-ONE data immobilizer bypass, doorlock, alarm & remote start interface with T-Harness combo module for 2013+ Ford vehicles.
It raises the standard of hassle-free installation convenience to a whole new level. It uses a multiple bus architecture with 10 separate communication ports that provide more complete functionality on every supported vehicle.
EVO-ALL Features:
3x on-board LEDs for simplified programming and diagnostics.
1x preloaded firmware for maximum compatibility.
4-wire Fortin 2-way datalink port for data-to-data (RS-232) communication with datalink equipped remote-starters and security-systems.
20-wire general purpose plug for wire-to-wire connections with non-datalink
The EVO-FORT2 is the ultimate Factory Fit, ALL-IN-ONE data immobilizer bypass, doorlock, alarm & remote start interface with T-Harness combo module for 2013+ Ford vehicles.
It raises the standard of hassle-free installation convenience to a whole new level. It uses a multiple bus architecture with 10 separate communication ports that provide more complete functionality on every supported vehicle.
EVO-ALL Features:
3x on-board LEDs for simplified programming and diagnostics.
1x preloaded firmware for maximum compatibility.
4-wire Fortin 2-way datalink port for data-to-data (RS-232) communication with datalink equipped remote-starters and security-systems
.
20-wire general purpose plug for wire-to-wire connections with non-datalink equipped remote-starters and security-systems
Self-Learning algorithm automatically detects the vehicle during programming and adjusts accordingly
Communication Ports
3x CAN-Bus controllers.
3x General purpose controllers (J1850, Class 2, encrypted key etc.).
2x On-board Relays (SPDT).
1x Analog Controller 0-12VDC @ 20mV steps (Passlock, MUX).
1x TB control port for TB-series modules
THAR-FORD2 Features:
EVO-ALL T-Harness for Ford vehicles
A T-Harness can now be used with the EVO-ALL to perform a full remote-starter and security installation
** These units required to be flashed/updated with a flashlink2 cable in order to set them up to use with your OEM key fob remote. Out of the box this unit will not funtion with your OEM remotes.
**  T-Harness may not complete installation and some wires may need to be hard wired into vehicle similar to a typical car starter install.
**  Check manufactorers web site to make sure your vehicle is comatible with this system