-40%
Red Sea Cuvette Holder & Drier - 4 Spots - 3D Printed - Many Colors
$ 6.6
- Description
- Size Guide
Description
This is a tabletop cuvette holder and drier for the Red Sea test kit cuvettes. You can use it as a holder and a drying rack. Each holder has spots for 4 cuvettes. When ordering a "two pack" you're getting two holders of 4 spots each (8 cuvette capacity total).Printed out of PLA.
Holds up to 4 cuvettes.
It has numbered spots so you can keep track of which cuvette goes where.
If no color is specified on the order notes, a black one will be sent out by default.
Check my other listings for the corresponding Red Sea and Salifert variants and also for wall mountable versions. I will accept reasonable offers for multiples.
Please note that these are 3D printed parts. That means that the surface finish quality of the part will not be directly comparable to an injection molded part. Although not very common, there might be small surface finish defects, or rough spots. The goal is to have a fully functional, as described part. This disadvantage to 3D printing is reflected on my pricing as well. Polished surface finishes, is definitely something that can be achieved to a certain degree with 3D printed parts, but it's a time consuming process, something that definitely cannot be offered for the price range my products go for.
If you have a color preference please make sure to put it on the "note to seller" field during checkout. If you do not do that, I
will use the default black color and
I may not be able to honor any request you have after your payment is complete.